Osburn 2500 Pellet Stove OP00025

Features:

• Fuel type: Pellet (Premium Grade or Better)
• Recommended heating area-ft²:  500 - 2,000
• Hopper capacity: 
• Maximum Burn Time: 51h
• Maximum heat input rate: 39,260 BTU/h (11.5 kW)
• Overall heat output rate: 6,648 BTU/h (1.95 kW) to 28,540 BTU/h (8.36 kW)
• Average overall efficiency: 70.3 % (HHV)  75.8 % LHV
• Optimum efficiency: 78,4%
• Optimum heat transfer efficiency: 73%
• Burn rate: 1.2 - 4.7 lb/h
• Average particulate emissions rate: 0.96 g/h 
• Average CO: 7.6 g/h
• Average electrical power consumption-ignition cycle: 2.60A (312W)
• Average electrical power consumption for continuous operation: 1.3A - 2.5A (51W- 140W)

Values are as measured per test method, except for the recommended heating area, firebox volume, maximum burn time, and maximum heat output.

Recommended heating area and maximum burn time may vary subject to location in the home, chimney draft, heat loss factors, climate, fuel type, and other variables. The recommended heated area for a given appliance is defined by the manufacturer as its capacity to maintain a minimum acceptable temperature in the designated area in case of a power failure.

The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft³ and 20 lb/ft³ and reloading intervals ranging from 60 to 120 minutes. Other performances are based on a fuel load prescribed by the standard without any reloading between start and finish. The specified loading density varies between 7 lb/ft³ and 12 lb/ft³. The moisture content is between 19% and 25%.

As measured per CSA B415.1-10 stack loss method.

• Higher Heating Value of the fuel.
• Lower Heating Value of the fuel.

Performances are based on a fuel load prescribed by the standard at 7 lb/ft³ and with a moisture content between 19% and 25%.

Optimum overall efficiency at a specific burn rate (LHV).

The optimum heat transfer efficiency is for the low burn rate (using HHV) and represents the appliance’s ability to convert the energy contained in the wood logs into energy transferred to the room in the form of heat and does not take into account the chemical losses during combustion.

This appliance is officially tested and certified by an independent agency.

Carbon monoxide.

Manuals:

• Installation Manual for Osburn 2500 Pellet Stove OP00025
• Operational Manual for Osburn 2500 Pellet Stove OP00025
• Specifications for Osburn 2500 Pellet Stove OP00025

Is this a right-sized unit for your Pellet Stove? Talk to an Expert at +1-800-923-4556 or email: support@flameauthority.com to ensure that this Pellet Stove is best suited for your needs. 

Specifications:

• Combustion technology: Top-feed
• High-efficiency certified appliance: Yes, EPA 2020 approved
• Electronic igniter: Yes
• Flue outlet diameter: 3"
• Type of chimney: ULC/ORD-C441, CAN/ULC S609, UL 641 (TYPE L)
• Baffle type: Stainless steel
• Approved for an alcove installation: Yes
• Approved for a mobile home installation: Yes, with fresh air intake
• Shipping Weight: 286 lb (130 kg)
• Door type: Single, glass with cast iron frame
• Safe and removable handle: N.A.
• Glass type: Ceramic glass
• Glass surface – dimensions (Width X Height): 17 1/4" X 9 1/2"
• Glass air-wash system: Yes
• Noise level at 6 feet: 47 bBa (+/- 3 dBa) - 60 dBa (+/- 3 dBa)
• Overall dimension: (Height) 33" (Width: 25 7/8" (Depth) 30"
• Adjustable threaded legs: Yes
• Easy-to-access ash drawer: N.A.
• Voltage and frequency: 120 VAC - 60 Hz
• AC Current: 1.3A/120VAC - 2.5A/120VAC
• Main control board fuses: 8A - 250V
• USA standard (emissions): EPA
• Canadian Standard (emissions): CSA B415.1-10
• USA standard (safety): UL 1482, ASTM E1509
• Canadian standard (safety): ULC S627
• Tested and listed as per applicable standards: By an accredited laboratory (CAN/USA) Warranty: Limited lifetime

Minimum Clearances to Combustibles:

(Data expressed in inches. 1 inch = 25.4 mm)

Canada

• Clearance - back wall - 3"
• Clearance - corner - 3"
• Clearance - side wall - 6"
• Clearance - top ( measured from the platform on which the appliance is installed) - 84"

United States

• Clearance - back wall - 3"
• Clearance - corner - 3"
• Clearance - side wall - 6"
• Clearance - top ( measured from the platform on which the appliance is installed) - 84"

The information given on the certification label affixed to the appliance always overrides the information published in any other media (owner's manual, catalogs, flyers, magazines, and/or websites).

Note: Some appliances have been tested with a low ceiling. Before setting up your unit, refer to the installation manual.

Options and Accessories:

2" X 25' Anti-Static Flex Hose - AC01465

3" X 10' Insulated Flex Pipe for Fresh Air Intake - AC02092

3" X 5' Fresh Air Intake Kit - AC01240

Digital Wall Thermostat - AC05558

• Fits on most thermostatically controlled pellet or gas appliances and furnaces. Temperature displayed in °C/°F. Includes 30 feet of millivolt wire.

Hopper Extension - AC01393

• Color: Black
• Optional accessory
• Product Dimensions: 24 5/8" W x 14" H x 11 5/8" D
• Increases the loading capacity of the pellet stove hopper by 140lbs.

Leg Assembly for - AC01463 Discharge Tank - AC01464 

Stand Alone Auxiliary Discharge Tank - AC01463 

Storage Tank Extension for AC01460 - AC01462

Storage Tank with Pneumatic Self-Feeding Pellet System - AC01460

• Similar in size to your 200-gallon oil tank, this innovative product can hold 35 bags of pellets of 40 pounds. Manufactured in Quebec, it meets the needs of consumers who want to save time and obtain a long heating autonomy for their pellet appliance. 

Tempered Glass Hearth Pad 10 MM - 44" X 36" - AC02704